Panasonic KX-NCP500 - 1-1] Slot-Card Property - Virtual IP Extension

3.14 [1-1] Slot—Card Property - Virtual IP Extension
The properties of the V-IPEXT card can be specified.
Signaling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
9300
Value Range
1–65535
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Manual References
9.1.15 IP-PT (IP Proprietary Telephone)
Signaling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
2727
Value Range
1–65535
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Manual References
9.1.15 IP-PT (IP Proprietary Telephone)
Document Version 2009-12 PC Programming Manual 155
3.14 [1-1] Slot—Card Property - Virtual IP Extension