Voice (RTP) UDP Port No. (IP-CS)
Specifies the UDP port used to transmit and receive RTP (Realtime Transfer Protocol) data on the IP-CS side.
This must be changed if another network application is using the same port.
For voice communications, an IP-CS uses 64 contiguous UDP ports, starting from the port number specified
here.
To change the value displayed here, click Common Settings and set the desired value.
Default
8000
Value Range
1–65024
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Manual References
None
Keep Alive Time-Out
Specifies the length of time that the PBX will continue to consider an IP-CS to be active even if it receives no
transmissions from that IP-CS. The PBX constantly confirms the status of IP-CSs. If no communications are
received from an IP-CS for the duration specified here, the PBX considers the IP-CS to be unreachable, and
sets the port status to Fault.
During operation, set between 10 s and 60 s. Settings over 60 s, and Disable, are used for debugging purposes,
and IP-CSs cannot be guaranteed to function normally in these circumstances. Do not use debugging settings
unless instructed to do so.
To change the value displayed here, click Common Settings and set the desired value.
Default
20 s
Value Range
Disable, 10–120 s
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Document Version 2009-12 PC Programming Manual 187
3.20 [1-1] Slot—Card Property - Virtual IPCS
To Next Page
Loading...
