Connection Settings for RS-232C
Setting Values Explanation
Port COMx Specify the number of the COM
port assigned to the PC’s
RS-232C interface. Only
available COM ports are
displayed.
Baud Rate (bps) 2400, 4800, 9600, 19200,
38400, 57600, 115200
Specify the speed of data
transmission.
Connection Settings for Modem
Setting
Values Explanation
Dial Number 1-9, 0, *, #, -, "," [comma], T, P,
W
Enter the telephone number to
be dialed to access the PBX.
T: Converts the Dial Type from
Pulse to Tone.
"," [comma], P, W: Inserts a
pause.
Dial Type Auto(Tone), Auto(Pulse),
Manual
Specify the outgoing dialing
method.
If Manual is chosen, dialing
must be done with a connected
telephone.
Comment Max. 40 characters Enter a comment to identify the
set of values.
Port COMx Specify the number of the COM
port assigned to the PC’s
modem interface.
Only available COM ports will
be displayed.
Baud Rate (bps) 1200, 2400, 4800, 9600,
19200, 38400
Specify the speed of data
transmission.
Modem Initialize – Enter the modem initialize
command, and click Initialize
to send the command to the
modem.
For more details, refer to your
modem’s instruction manual.
Connection Settings for LAN
Setting
Values Explanation
IP Address 1.0.0.0–223.255.255.255 Specify the IP address of the
PBX on the LAN. Enter the same
IP address that was input in
IP Address for IPCMPR Card
of 3.4 [1-1] Slot—Card
Property - IPCMPR.
Document Version 2009-12 PC Programming Manual 19
2.1.1 Starting Maintenance Console and Software Modes
To Next Page
Loading...
