Default
Not stored.
Value Range
Max. 16 digits (consisting of 0–9, *, and #)
Maintenance Console Location
3.31 [1-1] Slot—Port Property - PRI Port
Programming Manual References
None
Feature Manual References
3.1.15 CLIP (Calling Line Identification Presentation)
Ringback Tone to Outside Caller
Enables the PBX to send a ringback tone to an outside caller when the network cannot send the tone.
Default
Enable
Value Range
Disable, Enable
Maintenance Console Location
3.31 [1-1] Slot—Port Property - PRI Port
Programming Manual References
None
Feature Manual References
None
ISDN In/Out Call Type
Selects the method used to send dialed digits to the network.
Default
CO port: En-bloc
QSIG (slave/master) port: Overlap
Value Range
En-bloc: The PBX sends all of the dialed digits at once after the extension user completes dialing. The PBX
recognizes the end of dialing when (1) # is dialed, if programmed, (2) a preprogrammed telephone number is
dialed, or (3) the inter-digit timer expires.
Document Version 2009-12 PC Programming Manual 259
3.31 [1-1] Slot—Port Property - PRI Port
To Next Page
Loading...
