Sending Caller ID to TIE
Specifies whether Caller ID information is sent when the channel type is TIE.
Default
No
Value Range
Yes, No
Maintenance Console Location
3.34 [1-1] Slot—Port Property - T1 Port
Programming Manual References
None
Feature Manual References
None
Receiving Caller ID from TIE
Specifies whether Caller ID information is received when the channel type is TIE.
Default
Yes
Value Range
Yes, No
Maintenance Console Location
3.34 [1-1] Slot—Port Property - T1 Port
Programming Manual References
None
Feature Manual References
None
Ringback Tone to Outside Caller
Enables the PBX to send a ringback tone to an outside caller when the network cannot send the tone.
This setting is only available when Channel Type on this screen is set to DID.
Default
Enable
292 PC Programming Manual Document Version 2009-12
3.34 [1-1] Slot—Port Property - T1 Port
To Next Page
Loading...
