Value Range
Max. 8 digits (0–9, *, and #)
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
3.31 [1-1] Slot—Port Property - PRI Port— Calling Party Number—Type of Number—Public, Private
3.31 [1-1] Slot—Port Property - PRI Port— Called Party Number—Type of Number—Public, Private
Feature Manual References
3.1.3 Caller ID
Added Number (for National)
Specifies the number to be added to the incoming telephone number when the total number of digits exceeds
Minimum Caller ID Digits (for National) but does not exceed Minimum Caller ID Digits (for
International).
Default
Not stored.
Value Range
Max. 8 digits (0–9, *, and #)
Maintenance Console Location
5.3 [3-1-3] Caller ID Modification
Programming Manual References
3.31 [1-1] Slot—Port Property - PRI Port—
Calling Party Number—Type of Number—Public, Private
3.31 [1-1] Slot—Port Property - PRI Port— Called Party Number—Type of Number—Public, Private
Feature Manual References
3.1.3 Caller ID
CLIP
When incoming caller information is sent through an ISDN line and the type of the network numbering plan is
International, National, or Subscriber, the caller’s number can be modified as programmed in the Modification
Tables assigned to the trunk group. The modified number will then be recorded, and it is used for sending to
the network as a CLIP number.
A maximum of 4 CLIP Modification Tables can be programmed. Select the desired table from the Modification
Table list.
Document Version 2009-12 PC Programming Manual 463
5.3 [3-1-3] Caller ID Modification
To Next Page
Loading...
