DISA Intercept—Intercept when No Dial after DISA answers
Selects how DISA calls are handled if the caller does not select any option from the menu.
Default
to Operator
Value Range
to Operator, to AA-0, to AA-9, Disable (Reorder Tone)
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
None
Feature Manual References
None
CO-CO with DISA—DISA to Public CO
Specifies whether the DISA port of the message card is released when a CO-to-CO line call using DISA is
established. To enable this setting, " CO-CO with DISA—Fwd/Transfer to Public CO" on this screen should
be set to "Enable".
Setting this to "Disable" will free up DISA ports faster, but prevent DISA being used to detect the end of a call
and disconnect the CO line quickly.
Default
Enable
Value Range
Disable (Release DISA): The DISA port of the message card is released when a CO-to-CO line call using DISA
is established.
Enable: DISA stays connected for the duration of the call, to allow detection of the end of the call.
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
7.3 [5-3-1] Voice Message—DISA System—Option 1—
CO-CO with DISA—Fwd/Transfer to Public CO
Feature Manual References
None
710 PC Programming Manual Document Version 2009-12
7.3 [5-3-1] Voice Message—DISA System
To Next Page
Loading...
