Feature Manual References
None
DISA Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognized by the PBX. When the tone sent from
the telephone company is shorter than the value set here, the PBX recognizes it as a tone-on.
Note that this option can only be set when DISA Cyclic Tone Detection on this screen is set to "Option".
To apply changes to this setting, follow the steps below:
1. Change this setting.
2. Set the status of the OPB3 card to "OUS", then "INS".
Default
600 ms
Value Range
10 ´ n (n=11–400) ms
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
3.1 [1-1] Slot
3.36 [1-1] Slot—OPB3 Card Property
Feature Manual References
None
DISA Cyclic Tone Option—Tone Off Maximum Time
Specifies the maximum time that the PBX waits for a cyclic tone to be sent from the telephone company before
recognizing it as a tone-off. When no tone is detected within the time set here, the PBX recognizes it as a
tone-off.
Note that this option can only be set when DISA Cyclic Tone Detection on this screen is set to "Option".
To apply changes to this setting, follow the steps below:
1. Change this setting.
2. Set the status of the OPB3 card to "OUS", then "INS"
Default
600 ms
Value Range
10 ´ n (n=11–400) ms
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
714 PC Programming Manual Document Version 2009-12
7.3 [5-3-1] Voice Message—DISA System
To Next Page
Loading...
