Feature Manual References
16.1.8 SVM (Simplified Voice Message)
SVM Cyclic Tone Option—Tone On Maximum Time
Specifies the maximum duration of the cyclic tone that will be recognized by the PBX. When the tone sent from
the telephone company is shorter than the value set here, the PBX recognizes it as a tone-on.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to "Option".
To apply changes to this setting, follow the steps below:
1. Change this setting.
2. Set the status of the IPCMPR card or OPB3 card to "OUS", then "INS". See 3.5 [1-1] Slot—OPB3 Card
Property or 3.36 [1-1] Slot—OPB3 Card Property.
Default
600 ms
Value Range
20 ´ n (n=6–200) ms
Maintenance Console Location
7.5 [5-3-3] Voice Message—SVM
Programming Manual References
3.1 [1-1] Slot
Feature Manual References
16.1.8 SVM (Simplified Voice Message)
SVM Cyclic Tone Option—Tone Off Maximum Time
Specifies the maximum time that the PBX waits for a cyclic tone to be sent from the telephone company before
recognizing it as a tone-off. When no tone is detected within the time set here, the PBX recognizes it as a
tone-off.
Note that this option can only be set when SVM Cyclic Tone Detection on this screen is set to "Option".
To apply changes to this setting, follow the steps below:
1. Change this setting.
2. Set the status of the IPCMPR card or OPB3 card to "OUS", then "INS". See 3.5 [1-1] Slot—OPB3 Card
Property or 3.36 [1-1] Slot—OPB3 Card Property.
Default
600 ms
Value Range
20 ´ n (n=6–200) ms
Maintenance Console Location
7.5 [5-3-3] Voice Message—SVM
Document Version 2009-12 PC Programming Manual 723
7.5 [5-3-3] Voice Message—SVM
To Next Page
Loading...
