DID: Distribution depends on the DID number of the calls
Maintenance Console Location
12.2 [10-2] DIL Table & Port Settings
Programming Manual References
None
Feature Manual References
4.1.6 DID (Direct Inward Dialing)
9.1.10 INCOMING CALL FEATURES
DID/TIE—Remove Digit
Specifies the number of leading digits to be removed from the incoming called number for DID distribution or
for TIE line service.
Default
0
Value Range
0–15
Maintenance Console Location
12.2 [10-2] DIL Table & Port Settings
Programming Manual References
None
Feature Manual References
4.1.6 DID (Direct Inward Dialing)
13.1.15 PRIVATE NETWORK FEATURES
DID/TIE—Additional Dial
Specifies the number to be added to the incoming called number in the place of the removed digits for DID
distribution or for TIE line service.
Default
Not stored.
Value Range
Max. 8 digits (consisting of 0–9, *, and #)
Document Version 2009-12 PC Programming Manual 795
12.2 [10-2] DIL Table & Port Settings
To Next Page
Loading...
