Button Steps
Wrap-up Select Wrap-up from Type.
System Alarm Select System Alarm from Type.
Time Service (Day/Night/
Lunch/Break)
Select Time Service from Type.
Then in Parameter Selection, select which time modes will be
switched manually.
In Optional Parameter (Ringing Tone Type Number), select the Time
Table (tenant number) to be used for changing time modes in Automatic
Switching mode.
Answer Select Answer from Type.
Release Select Release from Type.
Toll Restriction/Call Barring
Select TRS Level Change from Type.
Then select the Toll Restriction/Call Barring Level (1–7) from Parameter
Selection.
ISDN Service
Select ISDN Service from Type.
Then enter the desired number in Dial (max. 32 digits consisting of 0–9,
, #, T [Transfer], [ ] [Secret], P [Pause], and F [Flash]).
Note
Availability of this button depends on the ISDN service of your
telephone company.
Refer to "1.2.5 Accessing the ISDN Service (ISDN Service
Access)".
Calling Line Identification
Restriction (CLIR)
Select CLIR from Type.
Connected Line Identification
Restriction (COLR)
Select COLR from Type.
ISDN-Hold Select ISDN Hold from Type.
Headset Select Headset from Type.
Time Service Switching Mode
(Automatic/Manual)
Select Time Service - Automatic/Manual from Type.
Then in Parameter Selection, select the Time Table (tenant number) to
be used when Time Service Switching Mode is set to Automatic.
Network Direct Station
Selection (NDSS)
Select NDSS from Type.
Then enter the another PBX extension number in Dial (max. 16 digits
consisting of 0–9).
Note
The button may not be available depending on the networking
method in use or the settings of the PBX.
CTI Select CTI from Type.
Primary Directory Number
(PDN)
Select PDN from Type.
3.2.1 User Programming
316 Operating Manual
To Next Page
Loading...
