8.2 Quick Setup
Programming Manual 115
4. Click Next.
The Step 3 screen will be displayed.
5. Enter the desired extension number and name (if required) for each jack to configure in the table.
• If you do not want to configure extension numbers and names, deselect the check box.
6. Click Next.
The Step 4 screen will be displayed.
7. For each outside (CO) line, select the ringing assignment.
• Select "All extensions" to have all extensions ring for calls from that outside (CO) line.
• Select a jack number to have only that extension ring for calls from that outside (CO) line.
• If you do not want to configure a particular outside (CO) line, deselect the check box beside the
name of that line.
To Next Page
Loading...
