Panasonic KX-TA824 - SLT Ring;Silence Ratio; SLT Ring Bell-On Time; SLT Caller ID Signaling Type

2.2 PT Programming—Procedures
30 Programming Manual
[142] SLT Ring/Silence Ratio
Selects the ratio between the bell signals of an SLT (a set of bell-on and bell-off).
Programming Manual References
[143] SLT Ring Bell-on Time
Feature Manual References
1.1.108 Ring Tone Pattern Selection
[143] SLT Ring Bell-on Time
This program selects the length of the bell-on signal of an SLT. This determines the ring tone pattern for
incoming calls to SLTs, combined with the setting in
[142] SLT Ring/Silence Ratio.
Conditions
• This program also determines the maximum number of digits of an SLT Caller ID number, when
"DTMF1" or "DTMF2" is selected in
[150] SLT Caller ID Signaling Type.
Programming Manual References
[142] SLT Ring/Silence Ratio
[150] SLT Caller ID Signaling Type
Feature Manual References
1.1.30 Caller ID
1.1.108 Ring Tone Pattern Selection
[150] SLT Caller ID Signaling Type
Selects the signaling type of SLT Caller ID.
Feature Manual References
1.1.30 Caller ID
1 4 2
NEXT SELECT STORE END
(1:2/ 1:3/1:4)
[On:Off]
1 4 3
NEXT SELECT STORE END
(1000
…
2000 ms)
[100 ms increments]
1300 ms
1 5 0
NEXT SELECT STORE END
( FSK1 [During ring]/
FSK2 [RP-AS]/
DTMF1 [Immediately]/
DTMF2 [During ring])