2.2 PT Programming—Procedures
78 Programming Manual
[967] TRS Check Time after Answering
Specifies the length of time that the DTMF signal is checked when "Enable" is selected in [966] TRS Check
after Answering.
Programming Manual References
[966] TRS Check after Answering
[968] KX-T7700 Series Incoming Lamp Control
Enables the Message/Ringer Lamp on the KX-T7700 series telephones for the following incoming calls:
a. Incoming call from an outside (CO) line with Caller ID information
b. Incoming call from another extension to a busy extension when the called extension has set Call
Waiting (Call Waiting Tone 1)
c. Incoming doorphone call whose ring tone pattern is set to "S-Double" in [706] Doorphone Ring
Tone Pattern (except when using the Paralleled Telephone feature) when an optional doorphone
or doorbell/door chime is connected to the PBX
Programming Manual References
[706] Doorphone Ring Tone Pattern
Feature Manual References
1.1.27 Call Waiting
1.1.28 Call Waiting Caller ID
1.1.47 Doorbell/Door Chime
1.1.48 Doorphone Call
1.1.82 Message Waiting
1.1.83 Message Waiting for Another Extension
[998] Firmware Version
Used to confirm the ROM and the firmware version of the PBX alternately by pressing SELECT.
Programming Manual References
[804] System Data Dump
Feature Manual References
1.1.58 Firmware Upgrade
9 6 7
NEXT
SELECT
STORE END
(5/10/ 15/
20/30/60 s)
9 6 8
NEXT END
SELECT
STORE
(Enable/ Disable)
9 9 8
NEXT END
Y871BA 050401 (M)
Version Date
Display Example
< ROM >
1.0.0
Version
< Firmware >
SELECT
SELECT
To Next Page
Loading...
