Panasonic KX-TA824 - Incoming;Outgoing Call Selection for Printing; Secret Number SMDR Print Suppression; System Data Dump

2.2 PT Programming—Procedures
70 Programming Manual
[802] Incoming/Outgoing Call Selection for Printing
Selects whether the dialed digits of incoming and outgoing outside (CO) line calls are printed.
Notes
Outgoing Call: On (Print all calls)/Off (No printing)/Toll (Print toll calls only)
Incoming Call: On (Print all calls)/Off (No printing)
Programming Manual References
[302-305] TRS—COS 2-5 Denied Code
Feature Manual References
1.1.112 Station Message Detail Recording (SMDR)
[803] Secret Number SMDR Print Suppression
Selects whether secret dialing numbers stored in System Speed Dialing or stored in One-touch Dialing
buttons are printed with SMDR. Secret dialing numbers are not shown on the displays of PTs, regardless of
this setting.
Programming Manual References
[001] System Speed Dialing Number
Feature Manual References
1.1.111 Secret Dialing
1.1.112 Station Message Detail Recording (SMDR)
[804] System Data Dump
Controls whether system programming items that have already been assigned are shown based on the
following parameters:
a. All para: All data
b. System para: All data except for "CO para", "Extn. para", "DSS para" and "Speed dial"
c. CO para: The data assigned for each outside (CO) line
d. Extn. para: The data assigned for each extension
e. DSS para: The data assigned on the DSS buttons and PF buttons on the DSS Console
f. Speed dial: The System Speed Dialing numbers and names in [001] System Speed Dialing
Number and [011] System Speed Dialing Name
g. Stop output: Not shown
8 0 2
NEXT
( On/Off/Toll) ( On/Off)
END SELECT STORE NEXT SELECT STORE
<Select an outgoing call> <Select an incoming call>
8 0 3
NEXT
( No Printing/
Printing)
END SELECT STORE