2.2 PT Programming—Procedures
Programming Manual 25
[103] DTMF Integration
Enables Inband (DTMF) Integration between the VPS and the PBX when a KX-TVS series VPS/KX-TVA
series VPS is connected to the PBX. The VPS and PBX communicate with each other by sending DTMF
signals.
Conditions
• In order to select "Enable" in this program, [130] VM 1 APT Port and [131] VM 2 APT Port should
first be set to "Disable".
• Please refer to 1.1.121 Voice Mail Inband (DTMF) Integration in the Feature Manual for details
about such as DTMF status signals.
Programming Manual References
[102] DTMF Integration Port
Feature Manual References
1.1.121 Voice Mail Inband (DTMF) Integration
[104] SLT Hold Mode
Selects how calls are held and transferred with an SLT when the Recall/hookswitch is pressed for less than
1000 ms.
Feature Manual References
1.1.15 Call Hold
[105] Conference Tone
Enables the PBX to send a confirmation tone before starting or ending a conference call established by the
Conference feature or Executive Busy Override feature.
Feature Manual References
1.1.33 Conference
1.1.50 Executive Busy Override—Extension
1.1.51 Executive Busy Override—Outside (CO) Line
[106] External Pager Access Tone
Enables the PBX to send a confirmation tone to the external pager before a paging announcement.
1 0 3
NEXT
SELECT
STORE END
(Enable/ Disable)
1 0 4
NEXT
SELECT
STORE END
( Hold-1/Hold-2/
Hold-3)
1 0 5
NEXT
SELECT
STORE END
( Enable/Disable)
1 0 6
NEXT
SELECT
STORE END
( Enable/Disable)
To Next Page
Loading...
