6.2 Disconnect
Programming Manual 101
The parameters are as follows:
6.2 Disconnect
Disconnects the PC from the PBX. Data transmission ends, and Maintenance Console returns to Initial
mode.
To disconnect
•From the Connect menu, select Disconnect.
If there is data that has been edited but not yet sent to the PBX, a confirmation window will be displayed.
•Click Yes to send the data to the PBX.
•Click No to discard the data.
Parameter Values Explanation
Dial Number 0-9, *, #, "-" (hyphen)
and "," (comma)
Telephone number to be dialed to access the
PBX.
Dial Type Auto (Tone), Auto
(Pulse), Manual
Outgoing dialing method. If "Manual" is
selected, a telephone must be connected in
parallel to dial.
Comment – Enter a comment to help to identify this profile.
Port COMx Specify the number of the COM port assigned
to the PC's modem interface. Only available
COM ports will be displayed.
Baud Rate (bps) 1200, 2400, 4800, 9600,
19200, 38400, 57600,
115200
Specify the speed of data transmission.
Flow Control None, Hardware Specify whether the rate of data transfer is
managed by hardware or not.
Modem Initialize Default, Custom Specifies the command used to initialize the
modem. If "Custom" is selected, enter the
initialize string in the text box. Refer to your
modem's instruction manual for more details.
Initialize – Click to send the specified initialize string to the
modem.
To Next Page
Loading...
