4.1 Software Modes
Programming Manual 89
When connecting the KX-TA Maintenance Console to the PBX using an RS-232C cable, assign the following
values to the Serial Interface (RS-232C) port of the PBX:
Baud Rate (bps): 9600
Word Length: 8 bits
Parity Bit: None
Stop Bit: 1 bit
Connection parameters for Modem
Word Length 8 bits Displays the number of bits in a word. This
value cannot be changed.
Stop Bit 1 bit Displays the length of the stop, used to identify
the end of a transmitted group of bits. This
value cannot be changed.
Parity Bit None Displays the kind of parity error-checking used.
This value cannot be changed.
Parameter Values Explanation
Dial Number 0-9, *, #, "-" (hyphen)
and "," (comma)
Telephone number to be dialed to access the
PBX.
Dial Type Auto (Tone), Auto
(Pulse), Manual
Outgoing dialing method. If "Manual" is
selected, a telephone must be connected in
parallel to dial.
Comment – Enter a comment to help to identify this profile.
Port COMx Specify the number of the COM port assigned
to the PC's modem interface. Only available
COM ports will be displayed.
Baud Rate (bps) 1200, 2400, 4800, 9600,
19200, 38400, 57600,
115200
Specify the speed of data transmission.
Flow Control None, Hardware Specify whether the rate of data transfer is
managed by hardware or not.
Modem Initialize Default, Custom Specifies the command used to initialize the
modem. If "Custom" is selected, enter the
initialize string in the text box. Refer to your
modem's instruction manual for more details.
Initialize – Click to send the specified initialize string to the
modem.
Parameter Values Explanation
To Next Page
Loading...
