2.8 Connection of DECT Portable Stations — KX-TDA100/KX-TDA200
Installation Manual 157
Registering the PS
The PS must be registered to the Hybrid IP-PBX before it can be used. Programming of both
the PS and Hybrid IP-PBX is required. A PT with multiline display (e.g., KX-T7636 6-line
display) is required for the Hybrid IP-PBX system programming.
Note
For details about system programming using a PT, refer to "2.3.2 PT Programming" and
"3.3 PT Programming" in the Feature Guide.
Entering the Hybrid IP-PBX System Programming Mode Using a PT
Administrator Level
Note
means default value.
PS Registration
One PS can be registered to a maximum of 4 different Hybrid IP-PBXs.
Using the KX-TCA155/KX-TCA255
#
= 1234
System Password for Administrator—
for PT Programming
Programming No.
3 digits
PROGRAM/
PAUSE
[690]
001 to 128
PS No.
1 to 4 digits
END
ENTER ENTER
To the PS
operation
below
Extn. No.
Select
"Setting Handset".
Select
"Register H/set".
Select
"Registration".
Select
"Base 1–4".
"Please wait".
"Enter Base PIN".
Press POWER
for 2 seconds.
C.Tone
4 digits
PIN for PS Registration
To Next Page
Loading...
