Panasonic WV-SW355

72
72 73
Configuration of the settings relating to the mail notification
[Notification]
Click the [Notification] tab on the "Alarm" page. (☞Pages24and25:Howtodisplay/operatethesetupmenu)
The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail server
to perform the mail notification. (☞ Page 80)
■ Mail notification
[Mail server >>]
When "Mail server >>" is clicked, the [Mail] tab of the
"Server" page will be displayed. (☞ Page 80)
[Mail notification]
Select"On"or"Off"todeterminewhetherornottopro-
vide notification by e-mail according to the settings for
the "Alarm" and "Diag." checkboxes of "Destination of
notification" below.
 • Whenanalarmisdetected("Alarm")
 • Whenanotificationoftheremainingcapacityofthe
SD memory card has been provided ("Diag.")
 • WhentheSDmemorycardhasbecomefull("Diag.")
 • WhentheSDmemorycardcannotberecognized
("Diag.")
Default:Off
[Alarm image attachment]
Select"On"or"Off"todeterminewhetherornotto
attach an image to the mail to be sent when an alarm is
detected.
Default:Off
Note:
 • Thesettingsfor"Imagecapturesize"ofthe"Alarm
image" section on the [Alarm] tab (☞ page 67) will
be applied to the size of the image to be attached.
■ Destination of notification
[Address 1] - [Address 4]
Enter the destination mail address. Up to 4 destination
addresses can be registered.
"Alarm" checkbox: When the checkbox is checked,
the mail notification will be performed upon an
alarm occurrence.
"Diag." checkbox: When the checkbox is checked, the
mail notification will be provided in the following
cases.
 • Whennotificationoftheremainingcapacityofthe
SD memory card has been provided
 • WhentheSDmemorycardhasbecomefull
 • WhentheSDmemorycardcannotberecognized
"Destination address": Enter the destination address.
Available number of characters: 3 - 128 charac-
ters
To delete the registered address, click the [Delete] but-
ton respective to the desired address.
[Mail subject]
Enter the mail subject.
Available number of characters: 0 - 50 characters
[Mail body]
Enter the mail body.
Available number of characters: 0 - 200 characters
Note:
 • Notification mail will be sent with the message "The
capacity of the SD memory card is full." when the
SD memory card becomes full, or "The SD memory
card cannot be detected." when mounting of the SD
memory card failed.