Panasonic WV-SW355

50
50 51
Configure the settings relating to MPEG-4 images
[JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Image/Audio" page. (☞Pages24and25:Howtodisplay/operatethesetup
menu)
The "JPEG/MPEG-4" tab will be displayed when "MPEG-4" is selected for "Video encoding format". (☞ Page 47)
Configure the settings relating to MPEG-4 image such as "Max bit rate (per client)*", "Image capture size", "Image
quality", etc. in this section. Refer to page 45 and 46 for the settings relating to JPEG images and H.264 images
respectively.
■ MPEG-4 (1) · MPEG-4 (2)
[MPEG-4 transmission]
Select"On"or"Off"todeterminewhetherornotto
transmit MPEG-4 images.
On: Transmits MPEG-4 images.
Off: Does not transmit MPEG-4 images.
Default:On
Important:
 • When"16:9"isselectedfor"Aspectratio",MPEG-4
transmission is unavailable.
 • When"H.264"isselectedfor"Recordingformat",
MPEG-4 transmission is unavailable.
Note:
 • When"On"isselectedfor"MPEG-4transmission"
in "MPEG-4(1)" or "MPEG-4(2)", displaying of
MPEG-4 images or JPEG images on the "Live" page
will be available.
 • When"On"isselectedfor"MPEG-4transmission"
in "MPEG-4(1)" and "MPEG-4(2)", MPEG-4 images
are viewable using other devices with each setting.
 • When"On"isselectedfor"MPEG-4transmission"
in "MPEG-4(1)" or "MPEG-4(2)", the transmission
interval of JPEG images may be longer.
[Internet mode (over HTTP)]
Select"On"whentransmittingMPEG-4imagesviathe
Internet. It is possible to transmit MPEG-4 images with-
out changing the broadband router settings configured
for JPEG image transmission.
On: MPEG-4 images and audio will be transmitted
using the HTTP port. Refer to page 84 for further
information about the HTTP port number settings.
Off: MPEG-4 images and audio will be transmitted
using the UDP port.
Default:Off
[Video encoding format]
Select MPEG-4 for a video format.