Panasonic WV-SW355

104
104 105
Procedure to register information for the "Viewnetcam" service
Step 1
ClickthedisplayedURL"https://**********"of"Your
Account Link".
→ The registration window for "Viewnetcam" will be
displayed in a newly opened window.
Step 2
Register the information for "Viewnetcam" by following
the instructions of the wizard.
→ When the registration window is not displayed,
check that the PC is being connected to the
Internet, and click the reload button of the browser.
When the message "The new camera is success-
fully registered to Viewnetcam.com" is displayed,
close the registration window.
The URL selected at the time of registration can be
used for camera access. However, this URL is
unavailable when accessing the camera from the
PC connected to the same network (LAN).
Note:
 • Whentheregistrationforthe"Viewnetcam"service
is completed, the URL of the camera registered for
"Personal(Camera) URL". It may take up to around
30 minutes until the URL of the registered camera is
validated.
 • Tocanceltheenrollmentinthe"Viewnetcam"ser-
vice,accessthe"Viewnetcam"website(http://www.
viewnetcam.com/) later.
 • Itispossibletochecktheinformationregisteredfor
the "Viewnetcam" service by accessing the URL
displayed beside "Your Account Link". When the
URL is not displayed, check that the PC is being
connected to the Internet, and click the [Set] button.
 • Ifaccessoftenfailsduetothechangeintheglobal
address of router, set a smaller value for "Access
interval".
Checking the information registered for the "Viewnetcam" service
It is possible to check if the camera has been registered for the "Viewnetcam" service. (☞ Page 114)