Panasonic WV-SW355

88
88 89
Configure the HTTPS settings
Click the [Network] tab on the "Network" page. (☞Pages24and25:Howtodisplay/operatethesetupmenu)
The settings relating to the HTTPS protocol that can enhance the network security by encrypting the access to
cameras on this page.
The HTTPS settings will be configured in the following procedure.
Note:
 • Tousetheservercertificate,youneedtoapplyfortheapprovalandtheissueofservercertificatebyCA.
 • Eitheroftheself-signedcertificateortheservercertificateisavailable.Ifbothofthemareinstalled,theserver
certificate will be used prior to the self-signed certificate.
Generation of the CRT key (SSL encryption key)
Configuration of the connection protocol
Access to the cameras using the HTTPS protocol
Application for the approval by CA
(Certificate Authority) - Issue of the server certificate
Generation of CSR (Certificate Signing Request)
Installation of the server certificate
Generation of the self-signed certificate
When using the server certificateWhen using the self-signed certificate
Generation of the CRT key (SSL encryption key) (☞ page 90)
Generation of the self-signed certificate (☞ page 91)
Generation of CSR (Certificate Signing Request) (☞ page 93)
Installation of the server certificate (☞ page 94)
Configuration of the connection protocol (☞ page 95)