Panasonic WV-SW355

62
62 63
Configure the settings relating to audio [Audio]
Click the [Audio] tab on the "Image/Audio" page. (☞Pages24and25:Howtodisplay/operatethesetupmenu)
The settings relating to audio can be configured on this page.
Note:
 • Imagesandaudiowillnotbesynchronized.Therefore,imagesandaudiomaynotalwaysmatch.
 • Audiomaybeinterrupteddependingonthenetworkenvironment.
[Audio transmission/reception]
Select the communication mode used for audio data
transmission/reception between the camera and the PC
from the following.
Off: Does not receive/transmit audio between the cam-
era and the PC. Therefore, the settings and controls
relating to audio will be invalidated.
Mic input: The PC receives audio data from the cam-
era. Audio can be heard with images on the PC.
Images and audio will not be synchronized.
Audio output: Audio data from the PC will be transmit-
ted to the camera. Audio can be heard from the
speaker connected to the camera.
Interactive(Half-duplex): Both reception and transmis-
sion are available. However, audio data cannot
simultaneously be transmitted and received.
Interactive(Full-duplex): Both reception and transmis-
sion are simultaneously available.
Default:Off
Note:
 • Howlingmaybegenerateddependingonusage
conditions. If howling is generated, prevent sound
generated by the PC from entering the PC micro-
phone.
 • When"Multicast"isselectedfor"Transmission
type" on the [JPEG/H.264] (or [JPEG/MPEG-4]) tab
of the "Image/Audio" page, audio transmission will
become unavailable while monitoring H.264 (or
MPEG-4) images. To transmit audio from a PC to
the camera, click the [JPEG] button on the "Live"
page.
[Audio encoding format]
Select the audio encoding format from G.726 and
G.711.
Default: G.726
Note:
 • Theotheri-PROseriesproductsdonotsupport
"G.711"unlessotherwisestated.(AsofOctober,
2010)
 • G.711isavailableonlywhen"Micinput"isselected
for "Audio transmission/reception".
[Audio bit rate]
Select "16kbps" or "32kbps" for the audio bit rate used
to transmit/receive audio data.
Default: 32kbps
Note:
 • Whenselectingasmallervaluefor"Bandwidth
control(bit rate)" (☞ page 87) while putting a priority
on the JPEG/MPEG-4 image transmission, select
"16kbps" for "Audio bit rate".
 • [Audiobitrate]isunavailablewhen"G.711"is
selected for "Audio encoding format".