Panasonic WV-SW355

68
68 69
[Image compression rate upon alarm detection]
Select"On"or"Off"todeterminewhetherornotto
change the image quality 1 (☞ page 46) upon alarm
detection.
On: Images will be transmitted with the image quality
selected for "Image quality1 upon alarm detection".
Off: Does not change the image quality upon alarm
detection.
Default:Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occur-
rence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
Default: 5 Normal
Configure the settings relating to H.264 recording [Alarm]
Click the [Alarm] tab on the "Alarm" page. (☞Pages24and25:Howtodisplay/operatethesetupmenu)
The settings relating to the recording H.264 data on the SD memory card when an alarm is detected can be config-
ured on this page. To operate recording, it is necessary to configure the settings relating to SD memory card and
the video data. (☞ Page 31)
■ H.264 recording
[Pre alarm]
Determine whether or not to perform the pre-alarm
recording. When "Use" is selected, 1 MB image data is
always saved during the pre alarm recording.
Use/ Not use
Default: Not use
[Post alarm (Recording) duration]
Set the duration to save image data on the SD memory
card after an alarm occurrence.
10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s
Default: 30s
* The actual recording time may sometimes be longer
than the duration selected for this setting.
[Recording (Memory) Size per an alarm]
The capacity of the SD memory card used to record
video data upon an alarm occurrence. The actual
capacity may be different.
Important:
 • TorecordH.264data,itisrequiredtoselect"Use"
for "SD memory card" on the [SD memory card] tab.
In addition, it is required to select "H.264" for
"Recording format". (☞ Page 31)