80
"- LEVEL EXPERT- PELLENC POWER TOOL BATTERY" Workshop document
Issue 11/2016 ref. : DOCUMENT ATELIER_BATTERIE_EXP_OUTILS_PELLENC_V2_2016_ENG
LEVEL 3 - PELLENC AUTHORISED REPAIRER
INSERTION OF THE FUSE ON THE 150 / 150P BATTERY
INSER
TION OF THE FUSE ON THE 200 BATTERY
- Remove the 8 screws under the battery using a PZ1 screwdriver.
- Lift off the upper casing.
- Put the 40A (58V) fuse in place.
- Replace the upper casing and do up the screws to a torque of 1.5 Nm
- Remove the 4 screws above the
battery using a PZ1 screwdriver.
- Remove the top part.
- Put the 15A (58V) fuse in place.
- If the cable has to be changed, remove the
card connector.
- Attach the connector of the new cable, and
put the rounded part of the grommet into the
battery neck.
- Replace the upper casing and do up the
screws to a torque of 0.8 Nm
To Next Page
Loading...
