81
"- LEVEL EXPERT- PELLENC POWER TOOL BATTERY" Workshop document
Issue 11/2016 ref. : DOCUMENT ATELIER_BATTERIE_EXP_OUTILS_PELLENC_V2_2016_ENG
LEVEL 3 - PELLENC AUTHORISED REPAIRER
INSERTION OF THE FUSE ON THE 400 / 700 / OLIVION AND 1100 BATTERY
INSER
TION OF THE FUSE ON THE 250 BATTERY
- Remove the 9 screws under the battery using
a PZ1 screwdriver.
- Lift off the upper casing.
- Put the 40A (58V) fuse in place.
- Replace the upper casing and do up the
screws to a torque of 1.5 Nm
N.B.: Check that the charger connector, tool
connector and switch are properly in place,
before closing the upper part of the battery.
- Turn the harness over and remove the 4
screws with a Torx 25 screwdriver
- Remove the 2 screws of the left cover from
the back of the tool using a PZ1 screwdriver.
- Put the 40A (58V) fuse in place.
- Replace the left cover and do up the 2 screws
to a torque of 1.2 Nm
- Replace the battery on the harness, reinsert
the 4 screws and tighten them to a torque of 1.5
Nm
To Next Page
Loading...
