104
Packaging and Transport
23. PACKAGING AND TRANSPORT
NOTE!
Transport damage!
Inadequately protected devices may be damaged during transportation.
• During transportation protect the device against moisture and dirt in shock-resistant packaging.
• Avoid the effects of heat and cold which could result in temperatures above or below the permitted storage
temperature.
Approved non-return and reusable transport containers are used for the transport ex factory and storage of the
control head. Preferably use this packaging.
If the control head is stored for further pre-assembly of a system, for example as part of a process valve module,
kindly make sure:
→ that the control head has been secured sufficiently!
→ that the electrical and pneumatic lines cannot be accidentally damaged and / or cannot indirectly damage the
control head!
→ that the control head is not used as support during packaging and transport!
→ that the control head is not exposed to any mechanical stress!
24. STORAGE
NOTE!
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature: -20 ... +65 °C.
Kindly make sure that the devices, following storage at low temperatures, are heated slowly to room temperature
before you carry out any assembly work on the devices or start operation of the devices!
25. DISPOSAL
→ Dispose of the device and packaging in an environmentally friendly manner.
NOTE!
Damage to the environment caused by device components contaminated with media.
• Observe the relevant disposal and environmental protection regulations.
Note:
Observe the national waste disposal regulations.
english
To Next Page
Loading...
