14
Reset Factory Defaults
The SuperFlo
®
VS Variable Speed Pump user interface has a “Reset to Factory Defaults” feature to restore the
schedule settings back to the original values programmed at the factory. The user must press and hold the STOP
and OVERRIDE buttons for three (3) seconds to reset the settings back to factory defaults. All of the UI bar graph
LED’s will ash three (3) times to conrm the settings were restored to factory defaults.
Priming
The pump will always run the PRIMING sequence when starting from the OFF state, except when starting in
OVERRIDE. The factory Prime settings are 2850 RPM for three (3) minutes.
Care and Maintenance
The pump is both reliable and robust in harsh environments. However, this product does contain electronics
that are cooled by a fan mounted to the pump. In order to ensure optimum reliability of this product, it is
recommended to clean the fan inlet on the back of the pump once a month. It is also important to keep this area
free of large debris such as leaves, branches, mulch, plastic bags, etc.
English
To Next Page
Loading...
Need help?
General
