35
Programming Corpus 3G/HD/APE/VS - Specific Attributes
Setting the IRM-positions
Setting the maximum rear position and the end position after the seats motion forward is performed as
follows.
• With the power turned off, press button 5 and 7 on the ICS control panel.
• Turn the power on by pressing the start button on the wheelchair’s control panel. ICS-control panel
buttons can be released when all the LEDs are lit green.
• LED 8 is now flashing red / green.
• For Corpus APE and Corpus VS only:
- Press button 7. Led 7 will lit solid green
• Maneuver the seat to the desired rear end position:
- Button 1 and 5 controls seat tilt function.
- Button 2 & 6 controls the leg rest.
- Button 3 & 7 controls the back rest.
• Press the button 4 to save position.
• Maneuver the seat to the desired front end position
- With 1 button and 5 runs seat tilt function
- The Key 2 & 6 runs legrest
- With key 3 & 7 running back rest
• Press the button 8 to save position.
• Turn the power ”Off” by pressing the start button on the wheelchair’s control panel.
To Next Page
Loading...