Adjustment
13 - 51
Message Description
E001 System error
E002 Sewing motor E002/BB/xxx
BB = 20: Time-out
02: Position forwards
03: Position in reverse
05: Position by shortest path
09: Write parameter
10: Speed
0A: Reset stitch counter
0B: Stop after xxx stitches
30: Time-out for increasing speed
31: Time-out for uncertain positioning
32: Time-out for time-out command
33: Time-out for deleting errors
34: Time-out for emergency stop
35: Time-out for writing parameters
36: Time-out for resetting stitch counter
37: Time-out for stop command after x stitches
38: Time-out for initialization
xxx = error bytes of sewing motor control unit (see Chapter 13.09 Sewing
Motor Errors)
E003 Section
E004 End of section
E005 Pedal activated when machine switched on
E007 End of ramp
E008 Reference for fullness adjustment not found
1: When moving towards sensor
2: When moving away from sensor
E009 Tape feed
1: Tape section too large when adjusting
2: Threading stopped after 2 attempts
E011 Stepping motor stepping frequency too high
E014 Incorrect program number (larger than 49)
E015 Incorrect seam section number
E016 Memory full
E021 Power supply unit overloaded
E022 Mains voltage
E023 Power supply 24V too low
E024 Error at CAN interface
13.10 Explanation of the error messages
To Next Page
Loading...
Need help?
General
