Adjustment
13 - 55
13.15 Internet update of the machine software
The machine software can be updated with PFAFF flash programming. For this purpose the
PFP boot program and the appropriate control software for the machine type must be installed
on a PC. To transfer the data to the machine, the PC and the machine control unit must be
connected with an appropriate null modem cable ( part no. 91-291 998-91 ).
The PFP boot program and the control software of the machine type
can be downloaded from the PFAFF-homepage using the following path:
www.pfaff-industrial.de/pfaff/de/service/downloads
To update the machine software carry out the following steps:
While the machine software is being updated, no setting up, maintenance or
adjustment work may be carried out on the machine!
● Switch off the machine.
● Connect the PC (serial interface or
appropriate USB-adapter) and the
machine control unit (RS232). To do so
disconnect the plug of the control panel.
● Switch on the PC and start the PFP boot
program.
● Select the machine type.
● Press the "programming" button.
● Hold down boot key 1 and switch on the
machine.
● Press the "OK" button.
● The software update is carried out, the update progress is shown on the bar display of
thePFP boot program.
● During the up-dating procedure the machine must not be switched off.
● When the update has been completed, switch off the machine and end the PFP boot
program.
● End the connection between the PC and the machine control unit and reconnect the control
panel to the machine control unit.
● Switch on the machine.
A plausibility control is carried out and, if necessary, a cold start.
More information and assistance is at your disposal in the file "PFPHILFE.TXT",
which can be called up from the PFP boot program by pressing the "help" button.
Fig. 13 - 43
1
To Next Page
Loading...
Need help?
General
