Preparation
9 - 1
Fig. 9 - 01
9 Preparation
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off
switch!
9.01 Inserting the needle
Switch off the machine!
Danger of injury by
unintentional starting of the
machine!
Only use needles from the
system intended for the
machine, see Chapter 3
Specifications.
● Set the needle bar at its highest point.
● Loosen screw 1.
● Push needle 2 fully into the needle bar
(the long needle groove must face to the
front).
● Tighten screw 1.
1
2
To Next Page
Loading...
Need help?
General
