Care and Maintenance
12 - 1
12.01 Cleaning
Switch the machine off!
Danger of injury if the machine
is started accidentally!
● Tilt sewing head back.
● Clean looper and looper compartment
daily, several times if in continuous
operation.
● When returning the machine to an upright
position, make sure that tilt lock 1 is
pressed.
Use both hands to set the
sewing head upright!
Danger of crushing between the
sewing head and the table top!
These maintenance intervals are calculated for the average running time of a sin-
gle shift operation. If the machine is operated for a longer period, shorter intervals
are recommended.
12 Care and Maintenance
Clean looper compartment .................................. daily, several times if in continuous use
Clean the entire machine............................................................................... once a week
Check the oil level ....................................................................................daily, before use
Lubricate the articulated joints of the top feed ............................................... once a week
Check/adjust the air pressure ...................................................................daily, before use
Clean air filter of air filter/regulator .................................................................... as required
Fig. 12 - 01
1
To Next Page
Loading...
