Input
11 - 5
● Change the graduated value.
The graduated value is used to adapt different garment sizes to the programmed basic
size.
● Select a seam type.
It is only possible to select the right or left sleeve seam if the seam type "right and left
sleeve seam" was selected in the basic setting, see Chapter 11.01.01 Basic setting for
seam program input.
● If necessary, insert the seam section.
The current seam section is copied and all following seam sections are set one place
back.
● If necessary, delete the current seam section.
● If necessary, conclude the input of the current seam and store the parameter for the
seam of the other sleeve in the reverse order (mirror seam).
● Set the seam end or program end.
If entering only one seam (only the right or only the left sleeve seam) the program end is
set in the desired seam section.
In the same way as the program end, the seam end is set when entering the right and
left sleeve seam. The seam end is set in the first sleeve seam and the program end in
the second sleeve seam.
● Conclude the input of the first seam section and change to the next seam section.
● Conclude the input and change to the input of the basic settings.
● Conclude the input and change to programmed sewing.
To Next Page
Loading...
Need help?
General
