26
Preparation
Fig. 9 - 01
9 Preparation
All regulations and notes in this Service Manual must be observed!
Special attention must be paid to the safety regulations!
All setting-up work must only be carried out by personnel with the appropriate
training!
9.01 Adjusting the feed roller clearance
● Switch on the machine.
● Lower the top feed roller.
● Loosen clamp screw 1.
● Adjust the clearance between the rollers with adjustment wheel 2 depending on the
workpiece and sealing method, see Chapter 7.06 Adjustment wheel for roller
clearance.
● Tighten clamp screw 1.
2
1
To Next Page
Loading...