41
Heat sealing
10.03 Creating/editing a heat sealing program
Up to 100 sealing programs (0 – 99) each with up to 20 sealing zones can be fi led and man-
aged in the machine memory.
● Call up the input menu.
● With the “programming” function from the input menu it is possible to enter the pro-
gramming function for sealing programs. A number block for entering the desired pro-
gram number appears.
If no program is fi led in the memory under the program number selected, the current seal-
ing parameter of the manual heat sealing function will be taken over and a new program cre-
ated.
As an alternative to the creation of a new program, the program number of an existing pro-
gram (e.g. 10) can be selected, and this program can be changed or copied to create a new
program. In the case of existing programs, the number of zones and possibly a comment are
displayed next to the program number in the headline.
● Enter the program number, e.g. "10".
● Confi rm selection.
Creating a new program
Altering a program
The fi rst zone of the selected program is displayed on the screen with functions for enter-
ing sealing parameters, notes, switching to the next zone, as well as basic functions for the
program input. For further descriptions of the functions see Chapter 10.03.07 Example for
sealing program input.
Example 1
Example 1
To Next Page
Loading...
Need help?
General