Adjustment
91
Fig. 13 - 12
2
1
1
13.11 Protective switch and boot key
The protective switch 1 serves as a protection against major damage in case
of a short circuit or overload. The boot key 2 is used to boot-up the machine
control unit, see Chapter 13.11.02 Loading/updating the operating program.
Disconnect the mains plug!
Danger from electric voltage!
Before switching the machine on again, fi rst eliminate the cause of the fault!
● Eliminate the cause of the fault.
● Open the control box and reset protective switch 1.
● Close the control box again.
To Next Page
Loading...