Adjustment
80
2
2
1
1
Fig. 13 - 01
13.03 Changing the feed rollers
● Switch on the machine and set the sealing temperature at its minimum value.
Let the heating element cool down!
Danger of burns if the heating element is touched!
● Call up the input menu.
● Lock the feed rollers.
● Change feed rollers 1 (screws 2).
If there is a difference between the diameters of the old and new feed
rollers, the machine must be re-confi gured, see Chapter 13.12.01 Machine
confi guration.
● Check the position of the feed rollers and correct it if necessary, see
Chapter 13.04 Adjusting the feed rollers.
● Switch off the machine.
To Next Page
Loading...