63
Input
#.#
bar
6.0
#.#
%
0.2
11.03.01 Feed roller parameters
In this menu the relevant parameters for the feed rollers are preset.
● Switch on the machine.
● Enter the input mode.
● Call up further settings.
● Call up the menu for entering the feed roller parameters.
Description of the functions
Input menu
This function is used to change from the initial state to the input mode.
Further settings
This function calls up the menu for entering further settings again.
Sealing mode
This function is used to change to the sealing mode.
Acceleration and brake profi les
This function is used to enter the values for the corresponding acceleration or brake profi les.
Feed roller pressure limit
This function is used to enter the maximum permissible value for the feed roller pressure.
Basic position of the top feed roller
This function is used to select the basic position of the top feed roller. The basic position of
the feed roller can be raised or lowered.
Feed difference inkrement
This function is used to enter the inkrement of the feed difference,
see chapter. 7.05 Triple foot switch.
To Next Page
Loading...
Need help?
General