43
Heat sealing
10.03.02 Basic functions for the program input
The following functions are used to enter the basic information for the currently selected
program. In addition to functions for navigating in the different zones and functions for in-
serting and deleting zones, depending on the zone displayed, functions can be called up for
entering further parameters and comments as well as for concluding the program input.
● Call up the appropriate functions to process or conclude the program.
Description of the functions
Selecting a zone
These functions are used to switch forwards and backwards to other zones in the current
program.
Insert
This function inserts a new zone at the current location. The data of the current zone are
copied for the new zone and the following zones are moved one place back.
Delete
This function deletes the current zone.
Further sealing parameters
(This function only appears in the fi rst zone.)
This function opens a menu for entering further sealing parameters, for example, nozzle or
hot wedge type, see also Chapter 10.03.05 Further sealing parameters.
Comment
(This function only appears in the fi rst zone.)
With this function, when entering a note, see Chapter 10.03.01 Notepad, the analog entry
of a comment about the current program is possible. The comment is displayed as informa-
tion about the appropriate program in the program selection and program management func-
tions.
Add
(This function only appears in the last zone.)
This function is used to copy the data of the current zone and add it as a new zone.
Conclude programming
This function concludes the programming, see Chapter 10.03.06 Concluding the program-
ming.
To Next Page
Loading...
Need help?
General