55
Heat sealing
Stop
(This function appears during the heat-sealing operation.)
This function is used to stop the heat-sealing operation, analog to pedal function "-1", also
see Chapter 7.03 Pedal.
Sequence programs are run as follows depending on the parameter setting
'Sequence continue':
Sequence continue = 1
The programs are executed in sequence according to the sequence
displayed. The currently executing program is shown inversely.
The sequence can be restarted at any point by pressing one of the program
buttons.
Sequence continue = 0
The selected program remains selected and is shown inversely. A different
program can be selected at any time by pressing one of the program buttons
(quick key selection).
To Next Page
Loading...