Transport and storage
11
3 Transport and storage
Upon delivery, check that the product has not been damaged during transport. If the
product is damaged, contact the carrier and notify the manufacturer. In all situations we
recommend:
keeping the product in its original packaging so it stays as clean as it was when dis-
patched by us. Only unpack the product once it is at the location where it will be used,
keeping the packaging (recyclable materials) in case the product needs to be trans-
ported or stored,
keeping the blanked-off flange on the inlet port when the product is not in use.
3.1 Transport
WARNING
Risk of injury associated with heavy loads
Given the weight of the product, it should be removed from its packaging only by per-
sonnel qualified and trained in handling heavy materials.
Use the yellow lifting handles installed on the product (re-install if they have been re-
moved).
The manufacturer cannot be held liable for the consequences of using lifting devices
other than those provided.
WARNING
Risk of tilting
Even though compliance with EEC safety rules is guaranteed (normal tilting ± 10°), all
necessary precautions should be taken when moving, installing and operating the pro-
duct.
When the detector is used on the trolley:
Attach the detector to the trolley.
Do not place the product on an inclined plane: its weight could cause the operator to
be dragged.
Place it on a flat, hard floor.
Do not push the product sideways.
Only use the trolley to move it short distances.
NOTICE
Work/Handling the detector
The operator must not work on the product to move it or carry out maintenance until it
has come to a complete shutdown! When the circuit breaker is set at "0", you must:
Unplug the power cable.
Wait for the control panel screen to turn off completely before working on the product
and/or removing the covers.
To Next Page
Loading...