Safety
8
2Safety
2.1 Safety precautions
Obligation to inform
Any person responsible for installing, using or maintaining the product must first read
the security instructions in this operating manual and comply with them.
It is the operating customer’s responsibility to protect all operators against the dan-
gers associated with the product, with the media pumped and with the entire instal-
lation.
Installation and use of the accessories
The products can be fitted with special accessories. The installation, use and refurbish-
ment of the connected accessories are described in detail in the respective manuals.
Only use original accessories.
Accessory part numbers: (see 10).
WARNING
Hazard associated with non-compliant electrical installation
Safe operation after installation is the operator’s responsibility.
Connect the product to an installation that is compliant with local safety standards.
Do not carry out any alterations or modifications to the product on your own initiative.
For specific questions, contact your service center.
WARNING
Electric shock hazard in case of contact
When the product's circuit breaker is set at "0", some internal components still have an
electrical charge.
Make sure that the mains connection is always visible and accessible so that it can
be unplugged at any time.
Disconnect the power cable from all power sources before starting any work on the
product.
WARNING
Other located hazardous energies
Electrical circuit and other pressurized circuits as nitrogen are potential hazards:
Always lock out these energy sources before working on the product.
WARNING
Risk associated with process gases
A leak detection operation must be carried out under environmental conditions that do
not present any risks to the operator and the equipment. The user and/or integrator of
the product are fully responsible for the operational safety conditions of the equipment.
Therefore the user of the detector must:
not test parts or equipment with traces of harsh, chemical, corrosive, inflammable, re-
active, toxic, or explosive substances, nor condensable vapours even in small
amounts. Do not use the nitrogen purge system to dilute these hazardous products:
that is not what it is intended for!
apply specific safety instructions in accordance with local regulations. For more infor-
mation, contact your service center.
To Next Page
Loading...