PFT G 4 X - Accessories

Mixing pump G 4 X smart Overview - Operation and service
Accessories
2021-08-12 19
14 Accessories
Fig. 14: Injection hood
PFT injection hood E1 for G 4
(article number 20600213).
The PFT injection hood is used for feeding dry material to the mixing pump
using the PFT SILOMAT pneumatic conveying system.
Fig. 15: Delivery hood
PFT delivery hood with off-load operation protection for G 4
(article number 20600500)
The PFT delivery hood is used for feeding dry material to the mixing pump
PFT G 4 directly from the silo / container. In case of an empty alarm in the
hopper, the mixing pump is switched of via the remote control socket.
Fig. 16: ROTOMIX
ROTOMIX D-pumps cmpl. with 35 coupling (article number 20118000)
Remixer for better decomposition and mixing of the material. Direct drive via
tang of the rotor. Contents approx. 1.2 l
Fig. 17: ROTOQUIRL
ROTOQUIRL II cmpl. with 35 coupling (article number 20118400)
Remixer for better decomposition and mixing of the material. Direct drive via
tang of the rotor. Contents approx. 4.2 l
Fig. 18: Water hose/air hose
Water hose/air hose 3/4" x 40m with Geka couplings (article
number 20212100)
Fig. 19: Remote control cable
Remote control cable 25m complete with ON/OFF switch and pilot lamp
(article number 20456929)
Fig. 20: Power cable
Power cable 5 x 4 mm² 25m with CEE plug and coupling 5 x 32A 6h red
(article number 20423920)