PFT G 4 X - Interruption of Work; In Case of Longer Interruption of Work;Break; Switch off Air Compressor

Mixing pump G 4 X smart Overview - Operation and service
Apply mortar
42 2021-08-12
37.2 Interruption of work
NOTE!
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on
the setting time of
the material and the length of the
interruption (pay atten
tion to outside temperature).
The guidelines of the material manufacturers have to
be observed regarding breaks.
1
Fig. 62: Closing the air tap
1. Close the air tap (1) if you interrupt your work for a short while.
2. The machine stops.
3. Once you open the air tap (1), the machine will start-up again.
37.3 In case of longer interruption of work/break
1
Fig. 63: Closing the air tap
Fig. 64: Switching off
1. Close air tap (1).
2. Switch off the machine, press the red push button (2) control
voltage “OFF”.
37.4 Switch off air compressor
Fig. 65: Air compressor
1. Switch off the air compressor at the red switch (1).
2. Open the air tap at the spraying gun.
DANGER!
Risk of injury from discharged mortar!
Discharged mortar may lead to injuries to eyes and
face.

Attention, residual pressure.
2
1