Mixing pump G 4 X smart Overview - Operation and service
Safety device
2021-08-12 31
Basic information
WARNING!
Danger of injury due to incorrect operation!
Improper operation may lead to serious damage to
persons or property.
Therefore:
Carry out all operating steps
instructions in this user manual.
Prior to starting your work, ensure that all covers and
protection devices are installed and work as intended.
Never deactivate protection devices during operation.
Ensure order and cleanliness in the work area! Loose
components and tools on top of another or lying about
pose potential accident risks.
Increased noise level may cause permanent hearing
deficiencies. At close range of the machine 95 dB(A)
can be exceeded due to operational conditions. Close
range is a distance of less than 5 metres to the
machine.
26 Safety device
26.1 EMERGENCY OFF pushbutton
Fig. 30: EMERGENCY OFF
pushbutton
HINWEIS!
Täglich vor Arbeitsbeginn den NOT-HALT Drucktaster
überprüfen.
NOTE!
Check the EMERGENCY OFF pushbutton
daily before starting work.
Switch on the main switch.
Control voltage “ON”.
Press the EMERGENCY OFF pushbutton.
The control voltage is switched off by pressing
the EMERGENCY OFF pushbutton!
NOTE!
The Emergency OFF button is used to quickly put
the machine into a safe state in case of danger or to avert
a danger.
The Emergency OFF button must lock after operation.
This immediately cuts off the energy supply to the drive elements.
Turning the Emergency OFF button returns it to its original position.
WARNING!
Danger to life by disabling safety devices!
Never carry out illegal actions on safety equipment that
endanger the life or health of employees.
To Next Page
Loading...
