PFT G 4 X - Remote Control; Working with the Remote Control; Stopping in Case of Emergency Emergency-Stop Switch; Emergency-Stop Switch

Mixing pump G 4 X smart Overview - Operation and service
Remote control
2021-08-12 43
38 Remote control
38.1 Working with the remote control
Fig. 66: Remote control
1. Remove dummy connector (1) from control cabinet.
2. Connect remote control (2).
3. The G 4 X can be switched on or off using the remote control.
39 Stopping in case of emergency Emergency-stop switch
39.1 Emergency-stop switch
Stopping in case of emergency In dangerous situation machine movements have to be stopped as
quickly as possible, and the power supply has to be disconnected.
Fig. 67: Stopping
After the rescue operations
In case of danger proceed as follows:
1. Turn main switch (0) to position "0".
2. Secure the main switch against reactivation.
3. Inform responsible person at the operational site.
4. If necessary call for medical assistance and fire brigade.
5. Recover persons from the danger zone, initiate First Aid
measures.
6. Keep access routes free for emergency vehicles.
7. If the severity of the emergency permits inform the competent
authorities.
8. Assign specialised personnel with the troubleshooting.
WARNING!
Danger to life from premature reactivation!
On reactivation there is danger to life for all
persons in the danger zone.
 Before reactivation ensure that there are no
persons in the danger zone anymore.
 For further information see book art. 00172709
General safety instructions for mixing pumps.
7. Check the system before reactivation and ensure that all safety
equipment is installed and functional.
2
1