Mixing pump G 4 X smart Overview - Operation and service
Examination
2021-08-12 7
2 Examination
2.1 Examination by machine operator
Prior to each shift, the machine operator has to examine the
effectiveness of the control and safety devices as well as the
proper fitting of the protection devices.
The safe working condition of construction machinery has to be
checked by the machine operator during operation.
If the safety devices show any defects or if any other defects are
detected that compromise a safe operation, the supervisor has to
be informed immediately.
In case of defects that cause harm to persons, the operation of the
construction machine has to be stopped to eliminate the defects.
2.2 Periodic inspection
Construction machinery has to be inspected for their safe working
condition in accordance with the operating conditions and the
operational requirements as needed, however at least once a year
by an expert.
Pressure vessels have to undergo the prescribed expert
inspections.
The inspection results have to be documented and kept at least
until the next inspection.
This heading contains test suggestions for the annual inspection by a specialist according to BGR 183 for
the G 4 X.
Knauf PFT - Downloads - Datenblätter
DOCUMENT CENTER
Use our wizard to find specific
downloads
Expert examination
Select your preferred language for
downloads
All languages
Search for downloads
Search
SEARCH RESULT
Designation Status Document type
SP04 G 4 X Aug. 2021 Expert examination
To Next Page
Loading...
