Mixing pump G 4 X smart Overview - Operation and service
Work on troubleshooting
2021-08-12 45
4 3
Fig. 70: Restart interlock
NOTE!
The G 4 X is equipped with a restart interlock. In
case of a power cut, the system has to be started as
follows.
4. Close the air tap at the spraying gun.
5. Turn main switch (3) to position "I".
6. Switch on the air compressor using the black switch.
7. Switch on the machine, press the green push button (4) control
voltage “ON”.
8. The G 4 X starts again as soon as the air tap at the spray gun is
opened again.
NOTE!
In case of a longer power cut, the G 4 X and the
material hoses have to be cleaned immediately.
41 Work on troubleshooting
41.1 Reaction in the event of faults
The following strictly applies:
1. In the event of faults presenting immediate danger to persons
or property, activate the emergency OFF function immediately.
2. Determine cause for fault.
3. If the rectification of faults requires works in the danger zone,
switch off the system and secure against restarting.
4. Inform the manager on site immediately about the fault.
5. Depending on the type of fault commission authorised skilled
personnel or rectify the fault yourself.
NOTE!
The following fault table gives information on who
is authorised to rectify the fault.
To Next Page
Loading...
